ENGINE FLUIDS AND LUBRICANTS — SRT
Component Fluid, Lubricant or Genuine Part
Engine/Intercooler Coolant
We recommend using Mopar® Antifreeze/Coolant 10 Year/150,000 Mile (240,000 km) Formula OAT (Organic Additive Technology)
that meets the requirements of the manufacturer Material Standard MS.90032.
Engine Oil
We recommend using Mopar® API Certified SAE 0W-40 Full Synthetic Engine Oil which meets the requirements of the manufac-
turer Material Standard MS-12633. Equivalent full synthetic SAE 0W-40 engine oil can be used but must have the API Donut trade-
mark
page 264.
Fuel Selection Premium Unleaded 91 Octane Only or Higher (R+M)/2 method, 0-15% ethanol (Do not use E-85).
CHASSIS FLUIDS AND LUBRICANTS — SRT
Component Fluid, Lubricant, or Genuine Part
Automatic Transmission
Use only Mopar® ZF8&9Speed ATF Automatic Transmission Fluid or equivalent. Failure to use the correct fluid may affect the
function or performance of your transmission.
Transfer Case – Single-Speed We recommend using Mopar® ATF+4 Automatic Transmission Fluid.
Axle Differential (Front) We recommend using Mopar® GL-5 Synthetic Axle Lubricant SAE 75W-85.
Axle Differential (Rear) – With Electronic
Limited-Slip Differential (ELSD)
We recommend using Mopar® GL-5 Synthetic Axle Lubricant SAE 75W-85 with integrated friction modifier.
Brake Master Cylinder
We recommend using Mopar® DOT 3 Brake Fluid, SAE J1703 should be used. If DOT 3 SAE J1703 brake fluid is not available, then
DOT 4 is acceptable.
If using DOT 4 brake fluid, the fluid must be changed every 24 months. This interval is time based only, mileage intervals do not
apply.
306 TECHNICAL SPECIFICATIONS
To Next Page
Loading...
Need help?
General
