DEPLOYING THE CROSSBARS
1. Starting with one crossbar, completely loosen the
thumb screws at both ends of the crossbar.
NOTE:
The thumb screws cannot be fully removed.
2. Remove the crossbar from the stowed position by
sliding the crossbar towards the center of the roof.
Repeat with the crossbar on the opposite side.
CAUTION!
Use care when removing and handling the crossbars
to prevent damage to the vehicle.
3. Starting with one crossbar, bend down the pivot sup-
ports at each end.
4. Position the crossbars across the roof making sure
the letters on the crossbars align with the matching
letters on the side rail.
5.
Slide the crossbar into the deploy position by moving it
towards the matching letter in the side rail. Be sure
the crossbar is fully deployed with the crossbar pushed
as far into the slot as possible. Once the crossbar is in
place, tighten both thumb screws completely.
Thumb Screw
Removing Crossbars
Bending Pivot
Positioning Crossbars
Installing Crossbars
66 GETTING TO KNOW YOUR VEHICLE
To Next Page
Loading...
Need help?
General
