6. Deploy and tighten the second crossbar to complete
the deployment of the crossbars.
STOWING THE CROSSBARS
1. Starting with one crossbar, completely loosen the
thumb screws at both ends. Slide the crossbar away
from the matching letter to remove it from the
deployed position. Repeat with the other crossbar.
CAUTION!
Use care when removing and handling the crossbars
to prevent damage to the vehicle.
2. Starting with the one crossbar, bend up the pivot
supports at each end.
3. Position the crossbar along the correct side rail.
Make sure the letters on the crossbar align with the
matching letters on the side rail.
4. Slide the crossbar outward, away from the center of
the roof. The crossbar will nest fully within the side
rail.
5. Once the driver’s side crossbar is in place, tighten
the thumb screws completely.
6. Repeat the procedure to stow the second crossbar
on the opposite side.
Deployed Crossbars
Crossbar Pivot
Stowing Crossbars
Crossbar To Side Rail
Tightening Crossbar
GETTING TO KNOW YOUR VEHICLE 67
2
To Next Page
Loading...
