The vehicle’s horn will rapidly chirp three times along
with a single flash of the vehicle’s exterior lights.
NOTE:
•
The doors have to be open and then closed in order
for the vehicle to detect a key fob. The Key Left
Vehicle feature will activate when the first door is
closed and no key fob is detected in the vehicle. If
the warning has been activated, and the other doors
are closed, no other warnings will be issued.
•
These alerts will not be activated in situations where
the vehicle’s engine is left running with the key fob
inside, or the key fob’s wireless signals are blocked.
Replacing The Battery In The Key Fob
The recommended replacement battery is one
CR2032 battery.
NOTE:
•
Customers are recommended to use a battery
obtained from Mopar®. Aftermarket coin battery
dimensions may not meet the original OEM coin
battery dimensions.
•
Perchlorate material — special handling may apply.
See www.dtsc.ca.gov/hazardouswaste/perchlorate
for further information.
•
Do not touch the battery terminals that are on the
back housing or the printed circuit board.
1. Remove the emergency key (2) by sliding the emer-
gency key release (1) on the back of the key fob and
pulling the emergency key out with your other hand.
2. Separate the key fob halves using a flat-blade
screwdriver or a coin, and gently pry the two halves
of the key fob apart. Make sure not to damage the
seal during removal.
3. Remove the back cover to access and replace the
battery. When replacing the battery, match the (+)
sign on the battery to the (+) sign on the inside of
the battery clip, located on the back cover. Avoid
touching the new battery with your fingers. Skin oils
may cause battery deterioration. If you touch a bat-
tery, clean it with rubbing alcohol.
Emergency Key Removal
1 — Emergency Key Release
2 — Emergency Key
Emergency Key Removal
Separating Case With A Coin
Key Fob Battery Replacement
GETTING TO KNOW YOUR VEHICLE 15
2
To Next Page
Loading...
Need help?
General
