WARNING!
•
Do not get under the vehicle when it is on a jack. If
you need to get under a raised vehicle, take it to a
service center where it can be raised on a lift.
•
Only use the jack in the positions indicated and for
lifting this vehicle during a tire change.
•
If working on or near a roadway, be extremely care-
ful of motor traffic.
•
To assure that spare tires, flat or inflated, are
securely stowed, spares must be stowed with the
valve stem facing the ground.
CAUTION!
Do not attempt to raise the vehicle by jacking on loca-
tions other than those indicated in the Jacking
Instructions for this vehicle.
1. Loosen (but do not remove) the wheel lug nuts by
turning them to the left, one turn, while the wheel is
still on the ground.
2. Assemble the jack and jacking tools.
NOTE:
Placement for the front and rear jacking locations
are critical. See the following images for proper jack-
ing locations.
3. For the front tire, place the jack on the body flange
just behind the front tire. Do not raise the vehicle
until you are sure the jack is fully engaged.
4. For a rear tire, place the jack in the slot on the rear
tie-down bracket, just forward of the rear tire. Do not
raise the vehicle until you are sure the jack is fully
engaged.
Jack Warning Label
Jack And Tool Assembly
Jacking Locations
Front Lifting Point
Front Jacking Location
IN CASE OF EMERGENCY 243
7
To Next Page
Loading...
