80 999817902 - 10/2022
General User Information Ringlock
Guide to Dismantling Ringlock Scaffolds
The dismantling of a Ringlock scaffold is no different
from most other types of scaffold. The dismantling pro-
cedure is the reverse of the erection procedure; the last
component installed is the first to be removed.
The following points are not to be considered unique to
the Ringlock scaffold, but used as a guide for safe prac-
tices.
▪ Prior to dismantling the scaffold. The Supervisor
should meet with all members of the dismantling
team to develop a safe plan of work which identifies,
controls, and/or removes all identifiable hazards.
▪ Monitor the site traffic in the immediate area during
the dismantling of the Ringlock Scaffold. If neces-
sary, barricade the area.
▪ Handle all components with care to minimize possi-
ble damage. The safety of those dismantling the
scaffold and passersby should take top priority dur-
ing dismantling.
▪ Before starting the dismantling procedure, inspect
the entire scaffold to ensure that it is still structurally
sound; that is, no parts have been damaged or
removed that would endanger workers on the scaf-
fold. If any such damage or missing part is seen,
those parts must be replaced before commencing
the operation.
▪ Do not remove a scaffold tie or structure connection
until the scaffold components above the tie have
been disassembled and lowered to the ground.
▪ Use temporary work platforms or loading platforms
at each level.
▪ All scaffolders should be wearing safety harnesses
and other appropriate PPE. Harnesses should be
attached to the scaffold at appropriate points (refer to
'Safety Harness Connection Points').
▪ Use ropes and slings to raise scaffold parts. Do not
throw components.
▪ Inspect all components to ensure that each one is
suitable. Identify all damaged components by tag-
ging or marking them conspicuously.
▪ Damaged components should be kept separated
from all of the other components in a quarantine
area.
To Next Page
Loading...
