Dometic 9100 - IMPORTANT SAFETY INSTRUCTIONS; Recognize Safety Information; Understand Signal Words; Supplemental Directives

3
This manual has safety information and instructions to help
you eliminate or reduce the risk of accidents and injuries.
A. Recognize Safety Information
This is the safety alert symbol. It is used to
alert you to potential physical injury hazards.
Obey all safety messages that follow this
symbol to avoid possible injury or death.
B. Understand Signal Words
A signal word will identify safety messages and
property damage messages, and will indicate the
degree or level of hazard seriousness.
 indicates a hazardous situation that,
if NOT avoided, could result in death or serious in-
jury.
 indicates a hazardous situation that,
if NOT avoided, could result in minor or moderate
injury.
 is used to address practices NOT
related to physical injury.
C. Supplemental Directives
Read and follow all safety information and
instructions to avoid possible injury or death.
Read and understand these instructions be-
fore installing, using, servicing or performing
maintenance on this product.
Incorrect installation, operation, servicing
or maintaining of this product can lead to
serious injury. Follow all instructions.
The installation MUST comply with all ap-
plicable local and national codes, including
the latest edition of the following standards:
U.S.A.
● ANSI/NFPA70, National Electrical Code
(NEC)
● ANSI/NFPA 1192, Recreational Vehicles
Code
CANADA
● CSA C22.1, Parts l & ll, Canadian Electri-
cal Code
● CSA Z240 RV Series, Recreational
Vehicles
D. General Safety Messages
 Failure to obey the following warn-
ings could result in death or serious injury:
● This product MUST be installed and serviced by
a qualied service technician.
● Do NOT modify this product in any way. Modica-
tion can be extremely hazardous.
● IMPACT OR CRUSH HAZARD. This product
should be installed in a controlled environment
(inside). Do NOT install product during windy
conditions, or when wind is expected. Otherwise,
product could move unpredictably, become un-
stable, and could detach, bend, or collapse.
IMPORTANT SAFETY INSTRUCTIONS
A. Included Hardware
(2) 1/4″ - 20 x 3/4″ Hex Head Screw
(2) 1/4″ Split Lock Washer
(8) #14 - 10 x 1-1/2″ Hex Head Screw
(2) #6 - 20 x 7/16″ Self Drilling Hex Head Washer
Screw
B. Optional Components & Kits
(1) 830304 Door Roller Kit
(1) 830304.003 Door Roller Kits (50 Pack)
(1) 3308334.006U Torsion Crank Assembly
(1) 3312853.025(#) Back Channel Spacer Kit
(1) 3316287.000 Rocker Switch Kit
GENERAL INFORMATION