EasyManua.ls Logo

Dometic Buttner MT LB50 - Scope of Delivery; Accessories; Intended Use

Dometic Buttner MT LB50
172 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
18 4445103618
A
NOTICE! Damage hazard
Only install the battery in environments with an
ambient temperature of at least 0 °C.
Avoid deep discharge of the batteries.
Scope of delivery
Accessories
Available as accessories (not included in the scope
of delivery):
Intended use
The battery charger (also referred to as charging
booster) is intended to monitor and charge 12 V
house batteries in motor homes from the alternator
while driving.
The charging booster is intended to be used to
charge the following battery types:
Lead acid batteries
Lead gel batteries
Absorbed glass mat (AGM) batteries
LiFePO4 batteries
The charging booster is not intended to be used
to charge other types of batteries (e.g. NiCd,
NiMH, etc.).
The charging booster is suitable for:
Installation in motor homes
Stationary or mobile use
Indoor use
The charging booster is not suitable for:
Mains operation
Outdoor use
This product is only suitable for the intended pur-
pose and application in accordance with these
instructions.
This manual provides information that is necessary
for proper installation and/or operation of the
product. Poor installation and/or improper operat-
ing or maintenance will result in unsatisfactory per-
formance and a possible failure.
The manufacturer accepts no liability for any injury
or damage to the product resulting from:
Incorrect assembly or connection, including
excess voltage
Incorrect maintenance or use of spare parts
other than original spare parts provided by the
manufacturer
Alterations to the product without express per-
mission from the manufacturer
Use for purposes other than those described in
this manual
Dometic reserves the right to change product
appearance and product specifications.
Quantity Description
1 MT LB 50, MT LB 60 or MT LB 90
1 Temperature sensor with cable (3 m)
1 Installation and Operating manual
Designation Ref. no.
Load relay (12 V, 100 A/ 180 A) with
installation cable set (for installation
variant C)
9620000184
(MT02156)
Installation cable set and terminal
block with sense cables and fuses
9620000188
(MT 93045)
Bypass relay (NC, 100 A) with instal-
lation cable set (installation variants
D1 and D2)
9620001495
(MT 93050)
Extension cable (5 m) with adapter
for display panel used for remote
control
9620000171
(MT 02005)
Charging cable set (2 m) with fuse
(250 A)
9620001496
(MT 22002)
Charging cable set (3 m) with fuse
(250 A)
9620001497
(MT 22003)
Charging cable set (4 m) with fuse
(250 A)
9620001498
(MT 22004)
Charging cable set (5 m) with fuse
(250 A)
9620001499
(MT 22005)
Charging cable set (6 m) with fuse
(250 A)
9620001500
(MT 22006)

Table of Contents