Dometic FreshWell 3000 - 8.2 Using the Remote Control; 8.3 Hint for Improved Use

EN
FreshWell3000 Operating the under-bench air conditioner
19
8.2 Using the remote control
The remote control must be pointed at the IR receiver (fig. 2 4, page 3) on the
receiver during operation.
When a button is pressed, the value is transmitted directly to the under-bench air
conditioner. The under-bench air conditioner confirms the receipt of data with a high
note.
Switching only the remote control to or from stand-by
In stand-by mode, the remote control display shows only the time.
If the remote control is not pointing to the IR receiver (fig. 2
4, page 3) on the
control panel, you can activate the remote control or switch it to stand-by
independently from the under-bench air conditioner:
➤ Press the button.
8.3 Hint for improved use
The following hints will optimise the performance of your under-bench air
conditioner:
• Improve the heat insulation of your vehicle by sealing gaps and hanging reflective
blinds or curtains on your windows.
• If the vehicle has been subjected to direct sunlight for a long time: Operate the
under-bench air conditioner in the “Circulating air” ( ) mode with the windows
open for a while before switching on the “Cooling” ( ) air conditioning mode.
• Avoid opening doors and windows as far as possible in the “Cooling” ( )
mode.
• Select an appropriate temperature and blower speed.
• Align the air nozzles sensibly.
• Make sure the air nozzles and intake grille are not covered by cloths, paper or
other objects.
• Clean the air filter periodically.
FreshWell3000-O-16s.book Seite 19 Freitag, 18. August 2017 2:14 14