76
Dometic
®
MANUAL
Refrigerators
3G. ICE MAKER – OTHER
WATER FILL ADJUSTMENT
The correct water level in the mold is important for the
proper production of ice. The size of the ice cubes
depends on the amount of water which enters the mold.
The cubes should be approximately 1/2" wide,
3/4" high and 2-1/2" long.
If the water overflows in the mold, first check to see if
the ice maker unit is level in the appliance. Next ensure
that the appliance is installed level in the RV.
If there is still water overflow, adjustment of the water fill
screw is necessary. Locate the screw on the ice maker
assembly. Turn the screw as necessary toward the "+"
or "—" side. One full turn of the screw will make an 18cc
change in the amount of water. DO NOT turn the screw
more than one full turn at a time.
If the water level is too high, it can also cause the ejector
blades to become frozen in the ice. Follow the proce-
dures above to correct the problem.
WATER FILL ADJUSTING SCREW
1 FULL TURN = 18 cc's CHANGE
To Next Page
Loading...
Need help?
General
