EN
WARNING! Risk of injury
• The device must be mounted and fastened in such a way that it cannot fall down.
• When positioning the device, ensure that all cables are suitably secured to avoid any form of trip
hazard.
NOTICE! Damage hazard
• Do not place the device near heat sources (heaters, direct sunlight, gas ovens, etc.).
• Mount the device in a dry location where it is protected against splashing water.
3.2 Safety when connecting the device electrically
DANGER! Electrocution hazard
If you are working on electrical systems, ensure that there is somebody close at hand who can help you in
emergencies.
WARNING! Electrocution hazard
• Observe the recommended cable cross-sections.
• Lay the cables so that they cannot be damaged by the doors or the hood. Crushed cables can lead
to serious injury.
NOTICE! Damage hazard
• Use ductwork or cable ducts if it is necessary to lay cables through metal panels or other panels with
sharp edges.
• Do not lay the cable so that it is loose or heavily kinked.
• Fasten the cables securely.
• Do not pull on the cables.
3.3 Operating the device safely
WARNING! Explosion hazard
• Only use the device in closed, well-ventilated rooms.
• Do not operate the device under the following conditions:
In salty, wet or damp environments
In the vicinity of corrosive fumes
In the vicinity of combustible materials
In areas where there is a danger of explosions
WARNING! Electrocution hazard
• Observe that parts of the device may still conduct voltage even if the fuse has blown.
• Do not disconnect any cables when the device is still in use.
NOTICE! Damage hazard
• Ensure that the air inlets and outlets of the device are not covered.
5
To Next Page
Loading...
Need help?
General
