Dometic SMP439 - Installing the Device; Fastening the Device

EN
SMP439, 439-08 Installing the device
13
6 Installing the device
6.1 Fastening the device
When selecting the installation location, observe the following instructions:
• The device should be installed vertically.
•Do not install the device
– In wet or damp environments
– In dusty environments
– In the vicinity of combustible materials
– In areas where there is a danger of explosions.
• The place of installation must be well ventilated. A ventilation system must be
available for installations in small, enclosed spaces. The clearance around the
device must be at least 25 cm.
• The air inlet on both short sides of the device must remain clear.
• For ambient temperatures higher than 40 °C (such as in engine or heating com-
partments, or direct sunlight), the heat from the device under load can lead to
reduced output.
7 Battery type selector button
8 Battery connector
No. in
fig. 2, page 4
Explanation/function: SMP439-08
1 Input for AC power supply
2 Battery connector A2, 10A
3 Status LED A2
4 LIN1 connection socket
5SMP-ON
6 Status LED A1
7 Battery type selector button
8 Battery connector A1, 15A
No. in
fig. 1, page 3
Explanation/function: SMP439