13
o Date: Change date here.
o Hour: Change time here.
o Day: Displayed
Next Screen:
o DST: Enabled (Default)
o Description Follows:
Menu D: Input/Output View values or status of analog sensors, digital inputs or relay outputs.
o A: Analog Inputs:
o CW Return
o Input B001: Actual Value
o Scroll for additional sensor values with down arrow button then ESC to exit.
o B: Digital Inputs:
o Flow Switch
o DI 3 Status: Actual State (Open or Closed)
o Scroll Down for additional active digital inputs. This will change depending on what is enabled in the system
configuration.
o C: Relay Outputs:
o SW Pump
o Relay 1 Status: Actual State (ON or OFF)
o Scroll Down for additional active relay outputs. This will change depending on what is enabled in the system
configuration.
o D: Analog Outputs:
o NOT USED
Menu E: Alarm History
Will capture the status of the following parameters at the time of the alarm. The most recent alarm will be shown. Use up arrow to
to view previous alarms.
o Alarm will be displayed followed by:
o Comp Speed: Actual value
o CW Return: Actual value
o CW Supply: Actual value
o Discharge Pres: Actual value
o Suct Pres: Actual value
Menu F: Board Switch
This menu allows you to change to view additional boards and make changes to that particular board. This only applies to a
multi-stage configuration when units are networked together.
o Unit Address: 1 (Default)
o Switch to unit: Desired board address
Menu G: Technician
Some subscreens will require a password. Please contact Dometic for service password.
Submenus:
To Next Page
Loading...
