Dometic VARC 72 - Power + n1 Regulation Details; EEV Pre-opening Settings

35
Program/Factory/Configuration/Power + n1 /Regulation
Regulation
Output frequency min #.# Hz
Output frequency max #.# Hz
Skip frequency set #(1-3) #.# Hz
Skip frequency band #(1-3) #.# Hz
Switching frequency # kHz
Switching frequency derating Disabled/Enabled
Speed derating mode #
Stop mode Ramp/Coast
Reverse Speed Disabled/Enabled
Flying Start Disabled/Enabled
Relay Configuration Select
PTC Alarm Disabled/Enabled
PTC Alarm delay # s
Compressor Regulator
Start-up pressure differential control
Max pressure diff. admitted #.# bar
Equalization mode Equalization valve/EEV Pre-opening
Start-up failure control
Pressure diff. min. variation #.# bar
Control period # s
Restart delay # s
Max Retry # #
Speed Management
Start-up forced speed #.# rps
Max speed #.# rps
Min speed #.# rps
Deceleration rate #.# rps/s
Acceleration rate #.# rps/s
Switch-off rate #.# rps/s
Envelope Control
Speed reduction rate #.# rps/s
Min speed admitted #.# rps
Out of env. Alarm timeout # s
Low press. diff. alarm timeout # s
Discharge Gas Control High Discharge Temp.
Limit #.# °C
Alarm #.# °C
Speed Control due to Discharge Gas
Action Distance #.# °C
Action Pause # s
Comp. Speed Reduction #.# %
EEV Regulation
Mode Suction
Superheat/Discharge/Temp./Disch. Superheat
Discharge Temp Probe Comp Time #.# s
Discharge Super Heat Temperature
Setpoint #.# °C #.# °C
Offset #.# °C #.# °C
Hysterisis #.# °C #.# °C
Envelope Control - Low ratio management
By EEV closing Yes/No
By compressor speed Yes/No
EEV Pre-opening *
Max. Equalization time ## s
EEV opening ##.# %