Dometic VARC 72 - Power + n1 Configuration; Power + n1 Settings

34
Program/Factory/Configuration/Power + n1
Regulation
See page 35
Custom
Num of Motor Poles #
Motor Control Mode PM Motor/AC Motor Vector/AC Motor
(V/F)
Motor base freq. #.# Hz
Motor base vol. # Vrms
Motor rated current #.# Arms
Motor power factor #
Out current maximum #.#%
Speed profile
Frequency # (1-3) #.# Hz
Acc. # (1-4) #.# Hz/s
Delay # ((1-3) # s
Delay execution Always/Single
Force freq. 2 Enabled/Disabled
Deceleration ramp #.# Hz/s
V/F Boost voltage #.#%
V/F Freq. adjustment #.#%
V/F Volt. Adjustment #.#%
Motor Mag. Current #.# A
Stator Resistance # mOhm
Rotor Resistance # mOhm
Stator/Ld inductance #.# mH
Leakage factor #
Lq Inductance #.# mH
Speed Loop Kp #.# %
Speed Loop Ki # ms
Magnetizing Time # ms
Starting Current #.# % #.# A
Freq. for Start Current #.# %
Crankcase heater Auto/Force Off/Force On
Crankcase current #.# % #.# A
STO alarm mngt Manual Res/Disable/Auto Reset
Phase loss detection Enable
Overload at Power-on Reset/Restored
Enable Manual R/W Yes/No
Address #
Read Value #
Write Value # Yes/No
Power + n1
Configuration
Regulation
Custom
Configuration
Motor Type Select
Set Defaults Yes/No
Save to Custom Yes/No
Data Comm. Timeout # s
U.M. speed Hz/rps
Drive Replacement Drive Replacement Do Nothing/Download
Parameters