INSTALLATION
EPT019297 Issue 1 November 2016 3-25
(4) If the printer is not already on, press and hold the power button for 2 seconds to switch
the printer on.
(5) Before inserting the cartridges in the printer, hold the cartridges near the Quality
Management Module (QMM) to check that the ink and make-up type is correct. The lights
on the QMM will flash amber to indicate that the RFID tags are being read. When the RFID
tags have successfully been read and validated, the lights will turn green. See “QMM
(Quality Management Module) Status Lights” on page 2-17.
Notes: (1) If a fault is detected, the QMM lights will turn red and an alert will be displayed on the
Status tab.
(2) If the RFID tag cannot be read, or an RFID tag is not present, the QMM lights will turn
solid amber.
(6) Insert a 6mm hex key into the top of the cartridges and twist to break the sealing tabs.
Remove the sealing tab.
Breaking the Seal on the Make-up Cartridge
Breaking the Seal on the Ink Cartridge
To Next Page
Loading...
Need help?
General
