18
ENGLISH
HOW TO PRESET TIME, DISTANCE, CALORIES and PULSE:
1. Press the MODE key until the preset item flashes.
2. Press the UP or DOWN key until the desired number is shown in
the LCD display.
3. Once the exercise has started, the preset function will begin to
count down.
4. It will beep for 12 seconds to indicate the completion of the preset
workout, press any key to stop the beeping.
REMARKS:
1. You are advised to preset only one item. If more than one item is
set, when the first preset item has reached the preset value, the
monitor will set off the alarm.
2. For PULSE window, the display will flash continuously when the
actual heart rate detected is above the preset value.
3. To exit the setting, please do not press MODE again but wait for
about 4 seconds until the display stops flashing.
HOW TO REMOVE BATTERY
1. Pull off the battery cover and place two SIZE-AA or UM-3 batteries
into the battery housing on the back of the monitor, please refer to
the illustrations below.
2. Make sure the batteries are correctly positioned and battery springs
are in proper contact with the batteries.
3. Install the battery cover and ensure it is tightly closed.
4. If the display is illegible or only partial segments appear, please
remove the battery; wait for 15 seconds, then reinstall it.
5. The batteries life is approx. two months under normal use.
6. Removing the batteries will erase the computer’s memory.
7. Take old batteries to the recycling centers intended for that
purpose.
SPECIFICATIONS
Time 0:00-99:59
Distance 0.01-99.99 KMS or Miles
FUNCTION Current SPEED 0.0-99.9 KPH or MPH
Pulse Rate 30-240 beats per minute
Calorie 0.1-99.9K.Cal
DISPLAY Liquid crystal type
CONTROLLER 4 bit Single chip microprocessor
SENSOR No-contact magnetic type
POWER SOURCE Requires 2 type AA or UM-3 batteries
OPERATING TEMPERATURE 0°C ~ +40°C (32°F~ 104°F)
STORAGE TEMPERATURE -10°C ~ +60°C (14°F~ 140°F)
To Next Page
Loading...
Need help?
General
