Transmission
MT-16
Adjustment of selective shift flexible shaft
1.Fit the ball joint assembly at the connecting end of
selective shift flexible shaft and gear shift, then push
the flexible shaft to the bottom to adjust the boll joint
and big nut, the dimension of A should meet the
requirement.
A=193±1mm
(1)Ball joint
(2)Adjusting nut
(3)Locking nut
2.Push the rear end of flexible shift to the bottom, screw
the adjusting nut to made the length of C is 214±1mm,
and ensure the angle relation ship of two ball joint and
the angle relationship of ball joints and flexible shaft
clip.
After finished the adjustment, tighten the adjusting
nut.
(1)Ball joint
(2)Adjusting nut
Installation of flexible shaft
The selective shift flexible shaft assembly adjusted
according to the above way can be assembled on the
truck.
1.Loosen the big nut of front end, let the flexible shaft go
through the bracket and the dirt boot plate, and then
tighten the big nut.
2.Connect the ball joint assembly with selective arm
together with self-locked nut. The flexible shaft dirt
boot must be fitted on the fixed plate.
1.Adjusting nut 2.Supporter
3.Ball joint 4.Locking nut
5.Selective arm 6.Operating shift
7.Floating supporter 8.Fixed plate
9.Dirt boot
3.Fit the front end of flexible shaft, then fit the rear end,
connect it with the transmission assembly, first fit the
To Next Page
Loading...