DONPER USA—USER MANUAL
11 — COPYRIGHT DONPER USA 2015
This equipment is intended to be installed in ac-
cordance with the National Electrical Code (NEC),
NFPA 70. A licensed electrician must install the
electrical connections for the machine to insure
safe operation. The machine must be properly
grounded. Failure to properly ground the machine
can result in severe bodily injury from electrical
shock.
ELECTRICIAN — When making the electrical connections,
note that the beater rotation must be counter clockwise as
viewed looking into the freezing cylinder from the front of the
machine. If the rotation direction is incorrect, it will be neces-
sary to change the position of the hot wires in the machine plug
to allow the motors to rotate in the correct direction.
To Next Page
Loading...
