DONPER BT7280 - Operating in Standby Mode

DONPER USA—USER MANUAL
16 — COPYRIGHT DONPER USA 2015
Adjusng the Product Firmness Level: (cont’)
The recommended starng seng for the product firmness level is 5.
With your product in the machine for the first me and the AUTO fea‐
ture running, wait unl the display cycles from 0 to 99 and then shows
00. Dispense some of the product from the machine and check the con‐
sistency/firmness. If a firmer product is desired, then increase the firm‐
ness seng by 1‐2 and allow the machine to recycle back to 00 again
and retest the firmness. Repeat this process unl the desired product
firmness is reached.
As a guide to help determine the appropriate product firmness seng,
the numbers on the display in AUTO mode should start at 0 and quickly
rise to about 84 to 87 when the product inside the freezing cylinders is in
a complete liquid state (for example, when the machine is first filled with
fresh product and started aer cleaning). If the numbers rise above 87
to start, then increase the firmness seng 1‐2 number values and re‐
start the AUTO mode and observe if the numbers stop increasing rapidly
somewhere near 84‐87.
OPERATING IN THE STANDBY MODE:
During long non‐use periods, the machine can be placed in Standby
Mode in order to keep the product inside the freezing cylinders refriger‐
ated.