DONPER USA—USER MANUAL
20 — COPYRIGHT DONPER USA 2015
Cleaning the Machine (Quick Rinse & Sanitize cont’)
Step 3: While the unit is in Wash Mode, place a large bucket be-
neath the dispenser door. Pull and hold all three (3) handles
down until all the water is removed from the machine. Press the
Wash button to turn Wash Mode off and discard the water.
Step 4: Repeat this rinse process 2-3 more times until the dis-
carded water becomes clear.
Step 5: Repeat steps 1-3 using water containing approved sani-
tizing solution and then rinse with a water solution.
Step 6: If the machine is to be immediately run with new product,
then pour 1-2 cups of the product into the hoppers, activate the
WASH mode, and dispense the product out the valves until the
water remaining in the cylinders is pushed out by the product.
If the machine is not going to be run immediately with new prod-
uct after cleaning, you will need to remove the dispensing door
and beater bars and dry the freezing cylinder and beater bar
components to prevent corrosion or oxidation (rust). Once you’ve
removed the dispensing door and beater bars it’s a good practice
to go ahead and do the full clean processof the components in a
sink with warm soapy water before reassembling the machine
parts (after clean rinsing and drying all parts).
.
To Next Page
Loading...
