STEP 5. Use one hand (same side as the foot blocking the rear wheel)
to hold the handle (#2) and with the other hand grab the stroller wheel
release (#17) at the back of the Doona Car Seat. Push in the red safety
lock (#18) and squeeze the wheel release handle up.
STEP 6. Lean the Doona Car Seat against the rear wheel (#7), blocked
by the foot, until the legs begin to fold.
STEP 7. Squeeze the stroller wheel release (#17) and lower the Doona
Car Seat all the way to the ground, until the legs are fully folded.
You should hear a click when the legs are locked.
22
11
The Doona car seat is now in carrier mode.
To install the Doona Car Seat in a vehicle, follow the instructions in this
user guide, Sections 11 or 12.
USE MODES
To Next Page
Loading...
