THE NEXT GENERATION CAR SEAT
12.1. Lap-Shoulder Belt European
Installation (preferred).
• The handle must be in position C (Car Seat
Mode) for correct installation in the car.
• The Doona Car Seat must be
properly reclined. The seat is
properly reclined when the red
level line on the side sticker is
parallel to the ground when
installed without the Doona
Base.
STEP 1: Place the Doona Car Seat rear-facing on the vehicle seat (child is
facing backwards).
NOTE: Doona recommends installing the Doona Car Seat only in a rear
vehicle seating position. If you must install your seat in a front vehicle
seating position, check your vehicle manual to verify that it is safe to install
a child restraint in this position.
To Next Page
Loading...
Need help?
General
