INSTALLING THE DOONA CAR SEAT WITHOUT A BASE
12.2. Lap-Shoulder Belt Standard
Installation.
• The handle must be in position
C for correct installation in the
car.
• The Doona Car Seat must be
properly reclined. The seat is
properly reclined when the red
level line on the side sticker is
parallel to the ground when installed without the
Doona Base.
STEP 1: Place the Doona Car Seat rear-facing on the vehicle seat (child is
facing backwards).
NOTE: Doona recommends installing the Doona Car Seat only in a rear
vehicle seating position. If you must install your seat in a front vehicle
seating position, check your vehicle manual to verify that it is safe to install
a child restraint in this position. The frontal airbag MUST be deactivated.
NOTE: Follow this method of installation when installing with an inatable
vehicle seatbelt or if the shoulder belt is not long enough to wrap around
the back of the Doona carrier.
To Next Page
Loading...
Need help?
General
