7
1838-065 Issued 3-19
Version D
1.2 Mounting Dimensions
If used to control a door or pedestrian gate, try to locate the access controller as close as possible to the entry point. The unit
should be mounted on a rigid wall to prevent excessive shock and vibration from closing doors or gates. Continuous vibration
and shock from slamming doors or spring-loaded pedestrian gates will damage the circuit board. Under no circumstances
should the unit be mounted directly to a moving door or gate.
10.25”
10”
12” 4”
Bottom View
Side ViewBack View Front View
.25” Dia. Mounting Holes
Mounting Hole Mounting Hole
10.75”
9”
.875” Dia 1.125” Dia 2.125” Dia
1.5”
3.75”
8.25”
10.5”
6”
2”
12.25”
Use appropriate hardware to secure
enclosure to surface (not supplied).
WARNING! If this entry system is used to
control a vehicular gate with an automatic gate
operator, the entry system must be mounted a
minimum of six (6) feet away from the gate and
gate operator, or in such a way that a person
cannot operate the entry system and touch the
gate or gate operator at the same time.
To Next Page
Loading...
