35
1838-065 Issued 3-19
Version D
This programming sequence is used to delete a single phone number under a known directory code.
3.5.6 Deleting Individual Phone Numbers
1. Press and enter your four-digit MASTER CODE (beep).
2. Enter the existing directory code (section 3.5.2 or 3.5.4) that the phone number has been assigned to (1, 2, 3 or 4 digits,
section 3.5.1), then press (beep).
3. Press , then press (beep).
4. Repeat steps 2 and 3 to delete additional phone numbers.
5. Press together to end this programming sequence (beeeeeep).
? ? ? ?
1
0
0
This program sequence deletes area code numbers that have been programmed into the 1838. Refer to section 3.5.4. for
programming on step 2.
3.5.8 Delete Area Codes
1. Press and enter your four-digit MASTER CODE (beep).
“Up to 255” programmed, OPTIONAL LCD display will read: 000 – 254 AAC POINTER
2.Enter the three-digit area code pointer (000 – 254), then press (beep).
The OPTIONAL LCD display will read: 4 DIGIT AREA CODE
3. Enter , then press (beep).
4. Repeat steps 2 or 2A and 3 to delete additional area codes.
5. Press together to end this programming sequence (beeeeeep).
? ? ? ?
4
2
0
If the 1838 is connected to a PBX telephone system rather than a dedicated C.O. line, you may need to set the unit to dial a line
access code prior to dialing the resident phone number. Typically, the line access code is “9”, but check with the PBX system
administrator to be sure.
3.5.10 PBX Line Access Code Programming
1. Press and enter your four-digit MASTER CODE (beep).
2. Enter the single-digit line access code number, then press (beep).
3. Press together to end this programming sequence (beeeeeep).
Note: To change a line access number, enter the correct number in step 2. To delete a line access number, enter # in step 2.
? ? ? ?
9
0
0
During touch-tone dialing, the 1838 (by default) places a 2 second pause after dialing a line access code (9 in a PBX system for
example) and after the area code. For example: 9 (2 second pause) 1310 (2 second pause) 6450023
The 2 second pause can be removed by programming 0 into the steps below. In this example, the 1838 would simply dial out
the line access code (9), area code (1310) and phone number (6450023) without any pauses. 913106450023
Factory setting is 1 (pause ON).
3.5.11 Touch-Tone Dialing Pause
1. Press and enter your four-digit MASTER CODE (beep).
2. Enter (beep) to turn the pause OFF, or enter (beep) to turn the pause ON.
5. Press together to end this programming sequence (beeeeeep).
? ? ? ?
7
2
0
0 1
To Next Page
Loading...
