DoorKing 1838 - 4-Digit Entry Code Programming

33
1838-065 Issued 3-19
Version D
1. Press and enter your four-digit MASTER CODE (beep).
The OPTIONAL LCD display will read: # OF DIRECTORY CODE DIGITS
2. Enter 1, 2, 3 or 4 digits, then press (beep).
The OPTIONAL LCD display will read: ERASE MEM? 1=Y 0=N
3. Entering will cancel out of this program if desired (beeeeeep).
Entering will change the directory code length (and erase ALL existing memory).
The OPTIONAL LCD display will read: ERASING
A long beep will sound when complete (beeeeeep).
Directory code digit length has now been programmed.
This programming sequence sets the directory code length to 1 - 2 - 3 or 4 digits.
Factory setting is three (3) digits.
These programming steps are ONLY used when a DKS 1838-120 or 1838-121 Remote Call Station is connected to the 1838.
CAUTION: This programming sequence will delete ALL phone numbers and
directory codes that have been previously programmed into the system.
3.5.1 Programming the Directory Code Length
? ? ? ?
0
2
0
1
In this programming sequence, the directory codes AND 7-digit phone numbers will be programmed into the system. Be sure
you have programmed the directory code length that you desire as described in 3.5.1 above. Changing the directory code
length after programming the telephone numbers will ERASE all the numbers and directory codes that have been
programmed. To program phone numbers that will need to use an area code (long distance calls and 10-digit calling), program
them in 3.5.4. Only three (3) directory codes are available; 0, 1, 2 (also 00, 000, 0000; 01, 001, 0001; 02, 002, 0002) depending
on the directory code length that was set in 3.5.1. Factory default directory code length is 3 (000, 001, 002).
Note: If the 1838 is being used in an area that requires 10-digit phone number dialing, proceed to 3.5.3 and 3.5.4 to program
the area code, phone number and directory code.
3.5.2 Programming Directory Codes with 7-Digit Phone Numbers - NO Area Code
1. Press and enter your four-digit MASTER CODE (beep).
2. Choose and enter a directory code (0, 00, 000, 0000 OR 1, 01, 001, 0001 OR 2, 02, 002, 0002), then
press (beep). (You cannot duplicate directory codes)
The OPTIONAL LCD display will read: PHONE#
3. Enter the seven-digit phone number, then press (beep).
Note: If the number that you are entering in this step is less than seven-digits, enter # in the empty spaces after the digits
have been entered.
For example, if the system is connected to a PBX that requires four-digit extension numbers and you want to enter extension
2217, you would enter this number as 2217###, then press
*
(beep).
4. Press together to end this programming sequence (beeeeeep).
? ? ? ?
1
0
0
3.5 Programming Phone Numbers