Operation Section
42
Monitoring Systems Indicator
Located on the middle of the console cover panel.
The symbols shown on the instrument panel
identify different features of the lift truck. The
symbol for each feature is identified and an
explanation of the function and location is described
on the following page.
Display Segments
The display gives the following information about the
operating state of the system:
Lift truck speed (expressed in kmh or
mph)
Warning symbol indicating that the
parking brake is being applied.
Low brake oil level; red LED
Safety contact open, indicated both by
EE blinking message visualized in
timemeter area and by relative symbol
With any directional switch active and safety
contact still open, lift truck can’t be moved, even
after seat switch is closed; in such a case, after
safety contact is closed, the symbol disappears.
EE code disappears only after active directional
switch is turned off.
Time gauge or odometer
Indicates steering angle
Maintenance notice: Notifies
maintenance schedule set time is arrived.
Turtle mode (Low speed operation
mode)
Economic, Standard or High Operation
mode
Speedometer having graduations from 0
(low) to 9 (high) segments.
Battery voltage level gauge having 9
segments.
Table 1 shows the relationship between the battery
charging progress and the No. of blocks. Both
36V/48V systems have the same relationship.
Warning code EL indicates that the batteries are
fully discharged.
LED Indicator
When switched, 4 LEDs appear in the left side of
the COMPACT display to provide following
information:
Warning message; red LED
Lamp message; green LED
Active indicator lamp; green LED (option)
Seat belt warning (option); red LED on for
10 s
NOTE: The warning LEDs indicate
following information
- Normal operation: LED turns on for a moment at
system switch on or off.
- Communication to control board is lost: LED
turns on after 3 s from the lost of communication
to the control board.
- Board microprocessor failure: warning LED turns
on
No warning, no operation. (Option)
If the parking brake is being applied, the drive
motor will not run even the accelerator pedal is
pressed when selecting the forward or reverse
directional control forward/reverse switch. Check
that if the parking brake switch is activated.
To Next Page
Loading...
