Operation Section
50
Sideshift Attachment Control
(If Equipped)
The sideshift attachment control is located at the
operator’s right side front. The sideshift attachment
control lever is the lever at the right.
Sideshift Left(1) - Push the lever forward
smoothly to shift the carriage to the left.
Sideshift Hold(2) - Release the sideshift
attachment lever. The lever will return to
the center(hold) position and sideshifting
action will stop.
Sideshift Right(3) - Pull the lever back
smoothly to shift the carriage to the right.
NOTE: To prevent a sudden change of position of
the load, operate all lift, tilt and attachment
controls smoothly.
Auto tilt control (If provided)
The auto tilt controller is on the left side of the tilt
knob. Press the auto tilt switch to turn on the switch
lamp and push the tile knob forward. The mast will
stop at 90 degrees angle.
NOTE: To prevent sudden position shift of the load,
operate the lift, tilting and side shift
controller smoothly.
To Next Page
Loading...
