Safety Section
6
General Warnings to Operator
WARNING
Only trained and authorized personnel may
operate this machine. For safe operation, read
and follow the operation and maintenance
Manual furnished with this lift truck and observe
the following warnings :
1. Before starting machine. Check all controls and
warning devices for proper operation.
2. Refer to machine identification plate for
allowable machine capacity. Do not overload.
Operate machines equipped with attachments
as partially loaded machines when not handling
a load.
3. Put directional control or shift lever in neutral
before "ON-OFF" switch is turned on.
4. Start, turn and brake smoothly. Slow down for
turns, slippery or uneven surfaces. Extremely
poor surfaces should be repaired. Avoid running
over loose objects or holes in the roadway
surfaces. Use extreme caution when turning on
inclines.
5. Travel with load as low as possible and tilted
back. If load interferes with visibility, travel with
load trailing.
6. On grade operations travel with load up grade.
7. Watch out for pedestrians and obstructions.
Check overhead clearances.
8. Do not permit riders on forks or machine at any
time.
9. Do not allow anyone to stand or pass under the
elevated portion of any machine.
10. Be sure operating surface can safely support
machine.
11. Operate machine and attachments only from
operator's position.
12. Do not handle unstable or loosely stacked loads.
13. Use minimum tilt when picking up or depositing
a load.
14. Use extreme care when handling long, high or
wide loads to ensure stability and durability of
the truck.
15. Forks should be completely under load and
spread apart as far as load permits.
16. Machine should be equipped with overhead
guard or equivalent protection. Where load
requires it, use load backrest extension. Use
extreme caution if operating without these
devices.
17. Lower the lifting fork on the floor for parking the
truck. Set the forward/reverse switch at neutral.
Check that parking brake lamp is on, and turn
the ignition switch to OFF position. Chock the
wheels when parking the truck on a slope.
Disconnect battery when parking an electric lift
truck.
18. When charging the batteries of an electric forklift,
observe safety instruction.
19.
The emergency switch uses in emergency really.
W
hen you use often emergency switch by key
switch, you can cause fatal mistake to your
machine.
20. If user operates continuously pushing work or
both brake pedal and accelerator pedal were
depressed at the same time, main electric parts
were able to damage.
To Next Page
Loading...
