Power Train Disassembly & Assembly
Observe all WARNINGS and CAUTIONS provided
by the press manufacturer concerning press
operation to avoid serious personal injury and
possible damage to components during assembly
and installation procedures.
6. Separate the case half and ring gear using a
press. Support the assembly under the ring gear
with metal or wood blocks and press the case half
through the gear.
7. If the differential bearings need to be replaced,
remove the bearing cones from the case halves.
Use a bearing puller or press.
Remove the Drive Pinion and
Bearing Cage from Carrier
1. Fasten a yoke bar to the input yoke. When the nut
is removed, the bar will hold the drive pinion in
position.
2. Remove the nut and washer from the drive pinion.
3. Remove the yoke bar.
4. Remove the yoke from the drive pinion. If the yoke
is tight on the pinion, use a puller for removal.
5. Remove the capscrews and washers that hold the
bearing cage in the carrier.
To Next Page
Loading...
