Power Train Disassembly & Assembly
8. Mount the inner and outer wheels. Install the
wheel nuts and tighten them to the specification.
NOTE : This is a common lubrication axle. Add
lubricant at the three locations until it runs out of the
fill/level holes.
9. Add the correct axle lubricant into each wheel end
through the fill/level hole in the planetary spider
cover (3) at the horizontal position (3 or 9 o’clock).
10. Add the correct lubricant to the axle housing bowl
area.
11. Apply sealant to the threads of the fill/level plugs.
12. Install the fill/level plugs and tighten them to 35
lb•ft (47 N•m).
61
To Next Page
Loading...
