- 133 -
LP Engine G430(3.0L) Base Engine Service Procedure
IMPORTANT: Place matchmarks or numbers on the
connecting rods and the connecting rod caps. Upon
removal of the piston and connecting rod assembly,
install the connecting rod caps to the matching
connecting rods.
2. Remove the connecting rod nuts.
3. Remove the connecting rod cap.
4. Remove the connecting rod bearings.
• Keep bearings with the original connecting rod
and connecting rod cap.
• Wipe the oil from the bearings.
• Wipe the oil from the crankpins.
5. Use the J 5239 in order to remove the connecting
rod and the piston out of the engine block.
6. Use a hammer and tap lightly on the end of the
connecting rod guide tool to remove the piston and
connecting rod assembly from the cylinder bore.
VE038-3LVE037-3L
To Next Page
Loading...
Need help?
General
