EasyManuals Logo

Doosan GC25P-3 User Manual

Doosan GC25P-3
182 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #94 background imageLoading...
Page #94 background image
- 93 -
LP Engine G430(3.0L) LP Fuel System (Low Emission Version)
Tests or Adjustments
Adhere to the following warnings when performing any
tests or adjustments while the engine is running.
Work carefully around an engine that is running.
Engine parts that are hot, or parts that are moving,
can cause personal injury.
Exhaust fumes contain carbon monoxide (CO)
which can cause personal injury or death. Start
and operate the engine in a well ventilated area
only. In an enclosed area, vent the exhaust to the
outside.
LP Carburetor-Check, Clean
Check and Clean LP Carburetor.
The LP Carburetor requires periodic inspection,
and cleaning. Inspection and cleaning are as
follows :
1. Start engine.
2. Close the liquid outlet valve in the fuel storage
container.
3. Run engine out of fuel.
4. Remove mixer lid (4).
5. Remove air valve (2) and spring (3).
6. Clean air valve with warm soapy water.
7. Clean mixer throat with approved carburetor
cleaner.
8. Inspect air valve and mixer throat for wear,
repair/replace as required.
9. When reassembling mixer, locate the notch on
air/gas valve diaphragm to point to fuel inlet.
10. Open the fule storage container liquid outlet
valve solwly.
11. Check for leaks.
12. start engine and verify normal operation.
Check engine idle speed
Check engine low idle speed. If it does not meet
specification, adjust idle speed adjustment screw.
Low idle speed specification
G430 : 800+/-25 rpm
WARNING
WARNING
1
2
3
4

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Doosan GC25P-3 and is the answer not in the manual?

Doosan GC25P-3 Specifications

General IconGeneral
BrandDoosan
ModelGC25P-3
CategoryEngine
LanguageEnglish

Related product manuals