- 132 -
LP Engine G430(3.0L) Base Engine Service Procedure
Timing Gear Oil Nozzle Removal
1. Remove the oil nozzle with pliers.
Piston, Connecting Rod and
Bearing Removal
Tools Required
• J 5239 Connecting Rod Guide Tool
• J 24270 Ridge Reamer
1. Remove the ring ridge as following:
(1) Turn the crankshaft until the piston is at the
bottom of the stroke.
(2) Place a cloth on top of the piston.
(3) Use the J 24270 to remove the cylinder ring
ridge.
(4) Turn the crankshaft so the piston is at the top of
the stroke.
(5) Remove the cloth.
(6) Remove the cutting debris.
VE036-3L
VE127-3L
To Next Page
Loading...
Need help?
General
