DOOSAN SERVO
66
3. Display / Setting switches
Display / Setting switch is applicable when using the operator
3.1 Functions
The 6 digits 7 segment display in front of the driver indicates parameter setting, position
compensation value setting, diagnosis,
alarm, and address and the data can be selected by
4 display mode.
( Display )
▶
When power is OFF, pre-set data is stored in the drive.
▶
Even if the power is turned off when the alarm is on the contents of the alarm is stored and
when the power is turned on again, the contents can be verified.
Caution : Turn the power voltage while mounting or dismounting the front panel.
To Next Page
Loading...
Need help?
General
