WN 058022 45532
11/1105
DORMA
Montageanleitung
Mounting instruction
ES 410 / 420
Main
closing edge
Secondary
closing edge
1. For your safety
This documentation contains important information
regarding the mounting and the safe operation of the door
system.
Please read these instructions carefully before using the
ES 410 / 420.
It is important for your personal safety to abide by all
enclosed instructions.
An incorrectly performed installation might cause serious
injuries.
Using control elements, making adjustments or performing
procedures that are not described in this documentation
might cause electric shocks, danger caused by electric
voltage/current and/or danger due to mechanical incidents.
Please keep these documents for further reference and hand
them over to the person in charge in case the system is
transferred to another party.
Explanation of symbols
NOTE This symbol underlines important
information that may facilitate your
work.
REMARK This symbol warns you of possible
system damage and explains how to
avoid this damage.
WARNING This symbol indicates dangers that
might cause personal or material
damage or even kill people.
Intended application
The ES 410 is only designed to open and close interior
sliding doors with an admissible door panel up to 200 kg,
the ES 420 is only designed to open and close interior
sliding doors with an admissible door panels up to 125 kg.
The ES 410 / 420 is not suitable for application in
emergency exits and escape routes
The ES 410 / 420 is not suitable for application at exterior
doors.
The maximum cable length for external components must
not exceed 30 m.
The system is connected to the door leaf via carriages.
Limitation of liability
The ES 410 / 420 may only be used according to its
specified intended application.
The DORMA GmnH + Co. KG will not accept any liability for
damage resulting from unauthorised modifications of the
ES 410 / 420. Furthermore components/accessories that
have not been approved by DORMA are exempted from
liability.
Safety instructions
Work on electrical equipment may only be performed
by properly qualified staff (electricians).
· Do not allow children to play with the
ES 410 / 420 or its adjustment and control devices.
· Keep remote controls out of reach of children.
· Never stick metal objects into the openings of the
ES 410 / 420; otherwise you might sustain an electric
shock.
· If the ES 410 / 420 is mounted onto a metal door leaf,
you have to earth (ground) the door leaf properly.
· Glass door leaves have to be made of safety glass.
Important technical data
· Power supply 230 V
· Fuse (by others) 16 A
· Operating noise < 70 dB(A)
· Temperatur range 0° - 40°
· Only suitable for dry environments max. 93%
relative humidity
non-condensing
Standards, laws, codes and regulations
· The latest versions of the common and country-specific
standards, laws, codes and regulations have to be
observed.
DIN 18650 (German Industrial Standard)
During the planning of the door system, the manufacturer
(the person installing the system) and the
commissioner/facility operator have to perform an individual
risk assessment (together).
Please refer to our homepage and consider
the provided “risk assessment form” under PRODUCT for
further assistance when performing your individual risk
assessment.
Danger spots at closing edges
Automatic doors might cause hazards by crushing,
shearing, hitting and drawing-in at the different
closing edges.
Residual risk
Depending on the structural conditions, the prevailing door
version and the available safety equipment, residual risks
such as crushing and hitting (with a limited force) cannot be
excluded.
Special requirements regarding the protection of people in
need of protection
In case the risk assessment reveals that there is a health
risk or risk of injury caused by the door hitting a person
using the door with an unacceptable force, an additional
protection with the aid of appropriate safety equipment
(connection of a safety sensor) is required.
This is especially necessary when people in need of
protection (children, elderly people or disabled people) use
the door
Recycling and disposal
Both the ES 410 / 420 and its packing mainly
consist of recyclable raw material.
The ES 410 / 420 and the respective
accessories must not be disposed of as domestic
waste.
Please ensure that the old appliance and the
respective accessories (if available) are properly
disposed of.
Please abide by the prevailing national statutory provisions.
www.dorma.com
To Next Page
Loading...
