EasyManuals Logo

Dormakaba ED100 User Manual

Dormakaba ED100
74 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #2 background imageLoading...
Page #2 background image
2
ED50/ED100/ED250 09-2021DL4617-003
dormakaba ED50/ED100/ED250 OHC Header
Setup and Troubleshooting Instructions
Table of Contents
Table of contents
General information
. General information
ED//ED OHC product
description 
ED//ED OHC door configurations
. OHC single door configurations
. OHC pair door and double egress door
configurations 
Technical data
. ED//ED technical data
. Operating specifications
Safety information
ED/ED/ED User interface 
. Overview 
.  button keypad and display 
. Operator status LEDs 
. Mode switch and Exit Only switch panel 
. ED/ED/ED automatic and
manual modes 
. Low and full energy doors 
System accessories 
. System accessory electrical connections 
. System accessories 
Terminal board connections 
ED/ED/ED door signage 
. Full energy operator 
. Low energy operator 
. Door signage, full energy single swing
doors (ANSI/BHMA A.) 
. Door signage, low energy single swing
doors (ANSI/BHMA A.) 
. Door signage, full energy pair swing doors
(ANSI/BHMA A.) 
. Door signage, low energy pair swing doors
(ANSI/BHMA A.) 
. Door signage, full energy double egress
swing doors (ANSI/BHMA A.) 
. Safety label, automatic swing doors 
. Safety label, low energy swing doors 
Table of contents
Parameters 
. ED/ED/ED OHC – viewing and
changing parameters 
. Configuration parameters 
. Driving parameters 
System setup for single door installation 
. Set operator spring tension 
. Set braking circuit plug position 
. ED/ED/ED OHC power on 
. Set installation type parameter AS 
. Set door width parameter Tb 
. Set OHC reveal depth parameter rd =  
. Set door type parameter dL 
. Perform partial learning cycle to rotate
arm to door installation position 
 Single door installation 
. Customer supplied single door -
installation 
. Prepare top of door for overhead arm 
. Prepare door for bottom door pivot and
install pivot 
. Install floor pivot shaft bearing 
. Hang door 
. Perform learning cycle 
 Set power fail closing speed 
. Set power fail closing speed 
 Pair door installation 
. Customer supplied doors - pair door
installation 
. Perform learning cycle for each door 
. Set power fail closing speed 
 Pair door parameters, Sync cable 
. Set ED operator parameters for pair door
operation 
. Connect Sync cable between
ED/ED/ED operators 
 Connect accessory wiring 
. Connect accessory wiring, single door 
. Connect accessory wiring, double doors 
 Install door signage, header cover 
. Install door signage 
. Install header cover 

Other manuals for Dormakaba ED100

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Dormakaba ED100 and is the answer not in the manual?

Dormakaba ED100 Specifications

General IconGeneral
TypeUniversal
PurposeInterior door
Product colorGray
Hand orientation-
Maximum door width- mm
Maximum door weight- kg
Placement supportedOverhead concealed door closer
Suitable for door typeSingle-leaf door
Power source typeDC
Weight and Dimensions IconWeight and Dimensions
Width1422 mm

Related product manuals