Dormakaba ED100 - 19 ANSI;BHMA standards; 19.2 Low energy power operated doors (ANSI;BHMA A156.19); 19.2.2 A156.19, Table I: Minimum opening and closing times

46
ED50/ED100/ED250 09-2021DL4617-002
dormakaba ED50/ED100/ED250 OHC Header
Setup and Troubleshooting Instructions
Chapter 19
ED/ED/ED Parameter A . standard
Parameter Function
Factory
setting
Adjustment range Para. Requirement
So Opening time
Swing door openin, knowing
act switch.
°/s °/s - /s .
Opening
Doors shall open from closed to back check or
°, whichever occurs first, in  seconds or
longer as required in Table I.
Total opening time to ° shall be as in Table II
(next page) If door opens at more than °, it
shall continue at the same rate as backcheck
speed.
bc Backcheck
Checking or slowing down of
door speed before door being
fully opened.
° ° - ° . Backcheck shall not occur before ° opening.
Sc Closing speed
Swing door closing speed,
automatic mode.
°/s
°/s - /s .
Closing
Doors shall close from ° to ° in  s or
longer as required in Table I (next page).
Doors shall close from ° to fully closed in not
less than . s.
dd
Hold open
time
Hold open time  s  s -  s .
Time delay
When powered open, the door shall remain
open at the fully opened position for not less
than  s.
Exception: when push-pull activation is used,
the door shall remain at the fully opened
position for not less than  s.
hS
Reference
Appendix A for
parameter
detail.
Support for manual mode in
door closed position.
.
Reference ANSI/BHMA A., Para.
., Force and Kinetic Energy.
hA
Adjustment, door activation
angle.
hF Power assist function.
Fo
Static force
in opening
direction
Static force on door closing
edge in opening direction.
Parameter
setting *
 N
. lb f
Parameter
setting *
 N -  N
. lb f - . lb f
.
The force required to prevent a stopped door
from opening or closing shall not exceed
 lb f [ N] measured " from latch edge of
the door at any point during opening or closing.
Fc
Static force
in closing
direction
Static force on door closing
edge in closing direction.
Parameter
setting *
 N (*)
. lb f
Parameter
setting *
 N -  N (*)
. lb f - . lb f
.
. Low energy power operated doors (ANSI/BHMA A.)
The following table references portions of content from ANSI/BHMA A.. Refer to the standard, available
through ANSI or BHMA for additional information. Standard material reprinted with BHMA permission.
.. Door measurements, low energy power operated door.
Note : Speed may be slower after learning cycle
completed.