Getting started
Important safety information
Only use the power cord and AC adapter included with the monitor, it provides the
correct type of power and was tested for use with your product.
Plug the power cord into an AC outlet that is always easily accessible. Disconnect
the monitor by grasping the plug firmly and pulling it from the AC outlet. Never
disconnect the monitor by pulling the cord.
The power cord is equipped with a three-wire grounded (earthed) plug. The plug
only fits in a grounded power outlet. Make sure the power outlet is properly
grounded before inserting the power cord plug. Do not disable the power cord
grounding pin, for example by attaching a 2-pin adapter. The grounding pin is an
important safety feature.
Be sure that the total ampere rating of the products connected to the AC outlet
does not exceed the current rating of the outlet, and that the total ampere rating of
the products connected to the cord does not exceed the rating of the cord. Also,
make sure that the total rating of all products plugged into the wall outlet does not
exceed the fuse rating. Look on the power label to determine the ampere rating
(AMPS or A) for each device.
Slots and openings in the cabinet are provided for ventilation. These openings must
not be blocked or covered. Never push objects of any kind into cabinet slots or other
openings, or spill liquid of any kind onto or into the product.
Keep the monitor in a well-ventilated area, away from excessive light, heat, or
moisture.
Do not use the monitor in any area with a potentially explosive atmosphere, as
sparks in such areas could cause an explosion or fire. Such areas are often (but not
always) marked and include areas where you would normally be advised to turn off
your vehicle engine, below deck on boats, chemical transfer or storage facilities,
vehicles using liquefied gas such as propane or butane, and areas where the air
contains chemicals or particles such as grain, dust, or metal powders.
For the protection of the monitor, as well as the computer, connect all power cords
for the computer and its peripheral devices (such as a monitor, printer, scanner) to
some form of surge protection device such as a power strip or uninterruptible power
supply (UPS). Not all power strips provide surge protection; the power strips must
be specifically labeled as having this capability. Use a power strip whose
manufacturer offers a damage replacement policy so you can replace the
equipment if surge protection fails.
To reduce the risk of serious injury, observe proper workstation setup, and proper
posture, health, and work habits for computer users.
Do not place anything on power cords or cables. Care should be taken to route or
arrange all cords and cables connected to Spectrum so that they cannot be pulled,
grabbed, stepped on, or tripped over.
To Next Page
Loading...
Need help?
General
