OPERATION
PRE-OPERATING INSTRUCTIONS
1-2
WARNING: DO NOT OPERATE BALER UNTIL OPERATING INSTRUCTIONS ARE
THOROUGHLY UNDERSTOOD. WEAR SAFETY GLASSES, AND GLOVES WHEN
OPERATING THIS EQUIPMENT.
STAY CLEAR OF ALL INTERNAL, AND EXTERNAL
MOVING PARTS WHEN OPERATING BALER.
FAILURE TO DO SO COULD RESULT IN SERIOUS
PERSONAL INJURY OR DEATH!
NEVER ENTER ANY PART OF BALER UNLESS DISCONNECT SWITCH HAS
BEEN TURNED OFF, AND LOCKED, AND ALL STORED ENERGY SOURCES
HAVE BEEN REMOVED. See Lock-Out & Tag-Out Instructions in Maintenance
section of this manual. Before starting baler, be sure no one is inside. Be certain
that everyone is clear of all points of operation, and pinch point areas before starting.
CAUTION: BE CERTAIN TURNBUCKLE AND LATCH ARE FULLY LOCKED IN
PLACE ON BALE CHAMBER DOOR BEFORE STARTING BALER.
EMPLOYERS SHOULD ALLOW ONLY AUTHORIZED,
AND THOROUGHLY TRAINED PERSONNEL TO
OPERATE THIS BALER.
This baler is equipped with a key operated locking system.
Keys should be in possession of only authorized personnel.
Federal regulation prohibits operation by persons under 18
years of age. Turn off, and remove key after use.
The baler hydraulic system operates at high pressures, and at high temperatures. If
you suspect a leak, DO NOT CHECK WITH YOUR HANDS
, and avoid contact with
piping, hoses, and cylinders.
ONLY AUTHORIZED PERSON-
NEL SHOULD BE ALLOWED
INSIDE PANEL BOX.
The panel
box contains high voltage components.
See Lock-Out & Tag-Out instructions
in Maintenance section.
To Next Page
Loading...
Need help?
General
