14
Connections
3.5 Ethernet Connection
The matrix comes equipped with an Ethernet port (RJ45 connector) which
allows the user to easily access the matrix from anywhere in the world via
TCP/IP on 100BaseT networks. See Section 4 and Section 6 for descriptions
regarding how to connect to, configure, and operate the matrix over this
100BaseT Ethernet connection.
3.6 USB Port
Connecting the matrix to a PC’s USB port should result in a “Found New
Hardware” event. Follow the instructions until prompted for the new hardware
device’s driver, which may be located on the CD shipped with the matrix.
After installation, the matrix’s USB port will appear as a virtual serial port.
Communicate to this port as you would on any RS 232 serial port. The baud
rate is 9600 b/s. See sections 3.3 and 6 for more details.
To Next Page
Loading...
Need help?
General