49
Remote Operation
6.6.3 Requesting Switch x current position
x = switch address.
Examples:
• ROUTE:SWITCHx?
• ROUT:SWITx?
• :SWITx?
Result:
Returns the current position of switch x.
Possible error codes
10, 11, 12, 13
Timing
The timing to execute a command depends on the length of the command (in
case of concatenated commands).
As a rule of thumb electromechanical switches require approximately 30ms to
switch position. It is safe to consider some safety margin and increase this
timing to 40-50 ms before issuing this command after setting a new switch
position.
Multiple switch commands are not executed in a sequential manner but rather
in parallel.
To Next Page
Loading...
Need help?
General