45
Remote Operation
6.5.14 SYST:STATUS?
Syntax
SYSTem:STATUS?
Description
This command will return all Switch positions, Local/Remote mode, Power
supply status, High temperature alarm status, Fan stall alarm and Errors
list separated by a semicolon.
Note 1: Power supply status, High temperature alarm status and Fan stall
alarm are only returned if enabled.
(Most models do not have redundant power supplies, temperature sensors
and fans and therefore will not report this status information)
Note 2: Multiple instances of the same error code will appear multiple
times. E.g. if two different switches fail to respond to CAN messages, two
instances of error 10 will be returned.
But multiple error instances of the same switch will appear only once.
Result
“SWITx y;SWITx y;SWITx y;…….;SWITx y;LOC;PWR1 OK;PWR2 FAULT;
ERRORS 5,3,0”
SWIT = Switch
X = Switch number (ID)
Y = Switch position
LOC = Local mode
REM = Remote mode
PWR1 = Power supply 1
PWR2 = Power supply 2 (Only for systems with dual power
supplies)
TEMP1= Temperature sensor 1 (Only if temp sensor 1 is enabled)
TEMP2= Temperature sensor 2 (Only if temp sensor 2 is enabled)
TEMP3= Temperature sensor 3 (Only if temp sensor 3 is enabled)
TEMP4= Temperature sensor 4 (Only if temp sensor 4 is enabled)
FAN1 = Fan 1 (Only if Fan sensor 1 is enabled)
FAN2 = Fan 2 (Only if Fan sensor 2 is enabled)
FAN3 = Fan 3 (Only if Fan sensor 3 is enabled)
FAN4 = Fan 4 (Only if Fan sensor 4 is enabled)
ERRORS = Error codes (Each number corresponds to a specific
error code described in the user manual. Not all error codes apply to the
matrix).
Possible error codes
None
To Next Page
Loading...
Need help?
General