A-15
POWER FAILURE
When the power comes back, the proofer will start automatically. Then it’s recommended to turn OFF the
unit to avoid it starting without supervision.
OPERATION OF THE PROOFER
1. Switch "ON" (1).
2. Set the thermostat control and humidity control according to the chart below.
Temp. F RH +/-5% Hum. position
90 75 4
95 4 1/2
95 75 4
95 4 1/2
100 75 4
95 4 1/2
110 80 4 1/2
90 5
3.If there is too much fog and water drips from the glass doors, adjust humidity control to a lower
number.
4. When the temperature is stabilised, put the products in the proofer.
5. IMPORTANT: When proofing cycle is completed, turn the humidity switch to "OFF" and let the
motor blower and air heat element run for 10-15 minutes to let dry the proofer. Then, turn the main
switch ‘’OFF’’ (0), and leave the door ajar to prevent moulding.
When the proofer is not in operation, open the doors to let out the humidity and to prevent mould.
P.S. During operation, the doors should not be opened unnecessarily to conserve the heat and humidity
in the proofer.
USE SOFT WATER ONLY.
Cleaning the water pan on top of the proofer periodically can prevent mineral problems.
To Next Page
Loading...
Need help?
General
