A-7
The installation must be made with a connector that meets with the standard for connectors movable gas
appliances ANSI Z21.69-XX and a Quick-disconnect device that complies with the standard for Quick-
disconnect devices for use with gas fuel ANSI Z21.41-XX and addenda Z21.41a-XX and Z21.41b-XX. Refer
to last edition year for XX. It must also be installed with restraining device (chain comes with the oven) to
guard against transmission of strain to the gas supply and connectors. The pipe fittings compound must be
certified for gas.
The customer must install a manual shut off valve at the end of the gas supply pipe near the burner
which is approved by the American Gas Association Standard in Canada with the Canadian Gas
Association.
Clean the air contained in the gas supply pipe at the installation to insure a successful firing on the first
try. The gas pipe sealing compound tightness must be verified using a solution of water and soap prior
to firing the unit.
ATTENTION
Make sure not to obstruct the overpressure opening on the gas regulator.
NOTE: If there’s any modification done to the system or change of the type of gas used, make
sure that the regulator pressure of the burner is adjusted as recommended in this manual.
To the electrician.
Electrical supply installation must be in accordance with the electrical rating on the nameplate.
Check if the rotation of the motor is in accordance with the arrow on top of each unit.
If NOT
If the power supply is 3 phases and the unit is not connected in the right phase sequence, the fan
motor will turn the wrong way. This will affect the baking quality. Turn the power “OFF” and
change the phase sequence.
WARNING
The electrician must make sure that the supply cable does not come in contact with the oven top which
becomes hot.
To Next Page
Loading...
Need help?
General
