To Next Page

To Previous Page

7.2.3 Using contactors

ATTENTION

Always place, using contactors and/or

auxiliary relays, a suitable RC filter or

varistor across the coil, e.g. Siemens

3RT29-16-1CD00

7.3 Commissioning

The control unit is fully programmed and preset with

factory default settings. Use the control panel, or the

service port to access the parameters of the program

which can be used to optimize the functionality of the

installation, (see: “Parameter list”).

Questions and Answers:

Need help?

Do you have a question about the DP Megacontrol Series and is the answer not in the manual?

DP Megacontrol Series Specifications

General