EasyManuals Logo

DP Megacontrol Series User Manual

DP Megacontrol Series
72 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #59 background imageLoading...
Page #59 background image
59
Internal Failure P# Not urgent
Mains Failure P# Not urgent
Over voltageP# Not urgent
Under voltage P# Not urgent
Overload Failure P# Not urgent
Brake resistor P# Not urgent
Temp. Failure P# Not urgent
ATM Failure P# Not urgent
Flushing Not urgent
Valve opened
oftenly
Urgent
Circuit Fail. FC# Not urgent
Ext. Power Opera-
tion
External power supply operation Not urgent
Setpoint Reduction Automatic Setpoint Reduction because of inlet pressure dropdown Not urgent
Factory Test Not urgent
MPO Failure Incorrect switching point configured or sensor failure Not urgent
ASR Shutdown Automatic Setpoint Reduction Shutdown because of inlet pressure dropdown Urgent
BC IO not con-
nected
Failure RW-pump 1 Failure rainwater pump 1. Solve problem and reset the system. Not urgent
Failure RW-pump 2 Failure rainwater pump 2. Solve problem and reset the system. Not urgent
No rainwater No rainwater is available. Not urgent
Failure DW-valve Failure of the drinking water inlet valve. Not urgent
Starts/h RW-pump 1 Maximum starts per hour of rainwater pump 1 are exceeded.
Starts/h RW-pump 2 Maximum starts per hour of rainwater pump 2 are exceeded.
Use of potable water Potable water was used. Not urgent
Hygienic addition The tank inlet was flushed with potable water. Not urgent
Forced hyg. Addition Flushing of tank inlet with potable water was forced. Not urgent
Manual Off RW-
pump 1
Manual Off RW-
pump 2
Manual On RW-
pump 1
Manual On RW-
pump 2
Tank filling The tank is filled due to a triggered start of the rainwater pumps.
Hyg. add. Incom-
plete
Hygienic addition was incomplete, because tank was filled or failure of drinking water inlet
valve.
Occured: Failures that have occurred recently.
Acknowledged: Failures that got acknowledged.
Cleared: Failures that got cleared
Data:
No failures
1. Manual alarm reset = Urgent.
2. Automatic alarm reset = Not urgent.
Failure message: Explanation: Failure
output:

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the DP Megacontrol Series and is the answer not in the manual?

DP Megacontrol Series Specifications

General IconGeneral
BrandDP
ModelMegacontrol Series
CategoryControl Unit
LanguageEnglish