EasyManuals Logo

DP Megacontrol Series User Manual

DP Megacontrol Series
72 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #61 background imageLoading...
Page #61 background image
61
12 Torque limit X X
13 Over Current X X X
14 Earth fault X X X
15 Hardware mismatch X X
16 Short Circuit X X
17 Control word time out (X) (X)
23 Internal fan fault X
24 External fan fault X
25 Brake resistor short-circuit X
26 Brake resistor power limit (X) (X)
27 Brake chopper fault X X
28 Brake check failed (X) (X)
29 Heatsink temp X X X
30 Motor phase U missing (X) (X) (X)
31 Motor phase V missing (X) (X) (X)
30 Motor phase W missing (X) (X) (X)
33 Inrush fault X X
34 Field bus communication fault X X
35 Out of frequency range X X
36 Mains failure X X
37 Phase imbalance X X
38 Internal fault
39 Heatsink sensor X X
40 Overload of digital output terminal 27 (X)
41 Overload of Digital Output Terminal 29 (X)
42 Overload of Digital Output On X30/6 or overload of digital out-
put on X30/7
(X)
46 Power card supply X X
47 24 V supply low X X X
48 1.8 V supply low X X
49 Speed limit X
50 AMA calibration failed X
51 AMA check U
nom
and I
nom
X
52 AMA low I
nom
X
53 AMA motor too big X
54 AMA motor too small X
55 AMA parameter out of range X
56 AMA interrupted by user X
57 AMA time out X
58 AMA internal fault X X
59 Current limit X
60 External interlock X
62 Output frequency at maximum limit X
64 Voltage limit X
65 Control Board Over-temperature X X X
66 Heat sink Temperature Low X
67 Option Configuration has Changed X
Error code: Explanation: Warning: Alarm/Trip: Alarm/Trip Lock:

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the DP Megacontrol Series and is the answer not in the manual?

DP Megacontrol Series Specifications

General IconGeneral
BrandDP
ModelMegacontrol Series
CategoryControl Unit
LanguageEnglish