63
29 Power board over temp X X X
30 Motor phase U missing X X
31 Motor phase V missing X X
32 Motor phase W missing X X
38 Internal fault X X
44 Earth fault X X
47 Control Voltage Fault X X
51 AMT check U
nom
and I
nom
X
52 AMT low I
nom
X
59 Current limit X
63 Mechanical Brake Low X
80 Drive Initialised to Default Value X
84 The connection between drive and LCP is lost X
85 Button disabled X
86 Copy fail X
87 LCP data invalid X
88 LCP data not compatible X
89 Parameter read only X
90 Parameter database busy X
91 Parameter value is not valid in this mode X
92 Parameter value exceeds the min/max limits X
nw run Not While RUNning X
Err. A wrong password was entered X
1. These faults may be caused by mains distortions. Installing Danfoss Line Filter may rectify this problem.
Error code: Explanation: Warning: Alarm: Trip lock: Error
To Next Page
Loading...